![]() I have updated the firmware a couple of times but it has always succeeded. I know I must have managed to program the board a couple of month ago when I bought it because the demo application that was on it is no longer running when I connect the usb cord. All it says is “cannot connect to target” and suggests I go to settings and choose “connect under reset”, but I see no such option. ![]() ![]() Anyone have any other suggestions?Īnother strange problem I have is that I tried to program my board using ST-LINK utility but it doesn’t detect it, so I cannot connect to it. There seems to be a similar problem in this thread but I did not get it to work with the proposed solutions. I get that error three times, then at the end: When I check the openocd console I see the following:Įrror: timed out while waiting for target halted Load D:\Daniel\SystemWorkbench\workspace\MLX90614\Debug\MLX90614.elfĮrror erasing flash with vFlashErase packet When I try to debug my application I get the following error message (at 93%): I am using System Workbench 1.13.1 on Windows 10 (圆4). ![]() I was planning on having some fun with my NUCLEO-F303K8 board today but before I got that far I stumbled upon some problems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |